There are a few very important things to be aware of before buying:
-
You'll need to make a simple measurement to see which size you'll require. Starting from the bit-center going under the gantry and far enough back to clear the gantry and anything behind it.
-
This boot fits our standard z-independent bracketing systems and we only have bracketing designed for machines listed in the drop-down. Adding other machines is a very slow process but you can ask support@pwncnc.com to be put into the design queue.
-
You MUST have (or are buying) our ultimate hose clamp with a 4" attachment. The 4" Vertical UHC Attachment is available separately if you already have the UHC. You'll also be expected to have a velcro strap or band clamp to secure the hose to the UHC. 4" hoses are extremely heavy and these boots are VERY long. You can/will not expect the boot to hold such a gigantic 4" hose by itself.
-
I have only tested this out on my personal machines... Shapeoko Pro and Onefinity. It does NOT have field validation... thus you are buying what is essentially an unproven boot that only incorporates my years of experience. Know going into this that there may be problems. You are expected, but not required, to provide feedback on the problems to support@pwncnc.com and give us ample time to properly address them.
-
If you are unhappy with the v9 boot for any reason, know that after the first use, full refunds are not available. However, returning it will earn you a partial trade-in provided in the form of store credit.
What's Included:
-
PwnCNC Dust Boot v9
-
Large acrylic boot "roof" and "floor" includes a large 66mm diameter opening.
-
1" brush and wings.
-
4" MagLock Round Adapter
What's not included:
- Z-Independent Bracketing purchased separately.
- Ultimate Hose Clamp with 4" Vertical Attachment
Deciding between 175mm and 220mm, here's how to measure for the v9: https://support.pwncnc.com/kb/article/67-measuring-for-v9/
Assembly Instructions https://support.pwncnc.com/kb/article/66-assemble-v9-dust-boot/