PwnCNC Dust Boot v2 in your choice of color
Boot Face in Black
Large sized acrylic boot "floor" with pass through for most router bits.
1" brush and wings
2.5" Adapter (SuckIt's... 2.28" ID /2.48" OD)
What's not included:
- Z-Independent Bracketing purchased separately.
I installed the dust boot v2 on my new spindle from PWN and have no complaints. It is working just liked they said. I like the rear boot for the types of projects I do. It is easy to set up and I like the fact you can take off the front cover brush and change a bit. So far it is a thumbs up for me! Thanks PWN
Very responsive in messaging, no complaints there. However, the dust boot took a while to get here. I did reach out to the seller and they did check on this issue for me. The issue I had was the holes in the acrylic piece was off pretty bad. I reached out and the response was when they cool the pieces would wrap by 10 percent. To fix it, I had to sand the sides and re drill two holes to make it work. A little to pricey for me to have to rig it up to make it work. I did get it to work. And it does work good in sucking dust.