VFD Keypad Mount for AltMill (bundle)

$60.00
Shipping calculated at checkout.

Pickup available at Headquarters

Usually ready in 2-4 days

As part of our continued efforts to support all machines out there.  Here is the perfect keypad mount for the new AltMill machine from Sienci Labs.

Made from steel sheets and 3d printing, this mount places our VFD's keypad and manual override switch into the perfect place within the left-front leg of your machine.

It perfectly matches the OEM VFD mounting location while adding our Manual-Override Switch easily accessible below.

What's Included:

  • L bracket for attaching to the AltMill Leg.  Allows for the E-Stop to also be mounted in the stock location. w/VFD Keypad mount
  • I bracket attaches to the L bracket and adds a mounting position for the MOS to be Mounted. w/MOS mount
  • 12ft MOS Extension Cable ($20 value)
  • 12ft Cat5 VFD Keypad Extension Cable ($16 value)
  • Hardware to put it all together

Note:  We have a limited number of these available, but will reorder as we get low.

You can find detailed installation instructions here:  https://support.pwncnc.com/kb/article/535-keypad-for-altmill/

Customer Reviews

Based on 1 review
0%
(0)
100%
(1)
0%
(0)
0%
(0)
0%
(0)
B
Bill Deerhake
VFD Keypad Mount for AltMill MK2

Installation was pretty easy. You have to remove emergency shutdown hold down plate and then reattach switch after installing mount. It doesn't allow for mounting VFD its self. I found getting the small key pad out of the plastic bracket difficult. I used thin piece of metal to release latches on each side.