MOTOR CONNECTORS set only. These are not compatible with the Chiller.
Do not overtighten these connectors. They are brass and over tightening will cause them to split.
Hand tighten only! We’ve installed hundreds of connectors without issue. Broken connectors will NOT be replaced.
I worked with Koolance to design a custom male fitting that screws directly onto your spindle; replacing the current tube connectors. These quick disconnect fittings feature a no-spill design that allows for extremely easy maintenance of your machine.
-
(2) PwnCNC Exclusive M8 Male fittings
-
(2) Tube 10/6mm Female fittings
Installation instructions can be found here: Kool Connectors
These connectors are fully compatible with our Clear Tubing, available by-the-foot.
If using with our Blue/Orange PU tubing, it helps to heat up the tip of the tube prior to pressing onto the female Kool connectors.
Note: If you ordered these with your spindle system, I will pre-install them onto your spindle motor and they come included with the ATC System
