🔌 Cable Inlets – For CNC Accessory Integration

Plug-n-Play Connectivity for Your CNC Accessories

Many of our accessories require a simple and reliable way to connect into your CNC controller. Our Cable Inlets provide just that—a clean, modular solution for routing signals through your control box, especially when using our Inlets Panel.

🧰 What Are Cable Inlets?

Cable inlets are pre-terminated connector assemblies that allow you to easily plug in accessories like:

✅ XYZ Probes
✅ Tool Setters
✅ External E-Stops
✅ Coolant & Extraction Control
✅ Chiller Alarm Cables
✅ ATC Components
✅ And More!

These connectors are designed to install cleanly into 12mm holes, such as those found in our Anodized Aluminum Inlets Panel, and provide a simple interface for wiring external devices into your controller.

🎯 Compatibility

Optimized for Masso Controllers
Our cable inlets are specifically tailored for Masso G3 and Masso Touch controllers. Most installations are plug-and-play using our Inlets Panel.
Other Controllers
While some cable inlets may work with other CNC controllers (e.g., Buildbotics, BlackBox, AVID, etc.), additional wiring or customization may be required. We’re happy to assist where possible, but support for non-Masso controllers is limited.

📦 How to Order

If a product requires a cable inlet, you'll see an option to add it during checkout—just select "Yes" to include the correct one with your order.

Looking for spare inlets or adding new accessories? Use this product page to order the specific inlet(s) you need.

Great Addition

Bought this not knowing if I really needed it. But after installing it I’m sure glad I did. Just neatens up additional add ons

Cable Inlets Panel

This is a much needed add on to the Onefinity Elite if you plan to run any add-ons.
Limiting the need to open the panel and disconnect from the controller just to re-route a wire is a huge time saver. I labeled the panel with the corresponding label on each wire to make it as fool proof as possible.
I have two small wires that weren't equipped with an aircraft style connector and needed to run them out of from under the 3D printed dust cover that come with the inlets panel. Instead of cutting a hole I emailed PWN CNC and asked for the 3d print file so I could make one to fit just those wires. Daniel was more than happy to send me the file. Best customer service in the CNC community!